Maintenance Of Crusher Parts

In the production of stone materials, the crusher is a commonly used equipment. It needs to be used for coarse crushing, fine crushing and stone shaping. The wear of the equipment is also relatively large. Therefore, to ensure normal and continuous production, the machine must first be guaranteed. Normal operation, do a good job of daily maintenance of the crusher, especially winter maintenance work. We remind our friends to do a thorough inspection and maintenance of the crusher before the winter comes, to ensure that the construction machinery is safe for the winter, so as to avoid the impact of the machine on the production.

Maintenance Of Crusher Parts

First, the cleaning of the crusher

The appearance of the diesel engine, the chassis and the working device of the cleaning engineering machine can play the role of descaling and decontamination. In the cleaning process, problems such as damage to various devices, components and oil leakage can be found, and the preliminary work for the next maintenance and repair can be done. . It is strictly forbidden to use high-pressure and high-temperature water guns to rinse the parts with high waterproof requirements, especially the electrical parts, so as not to cause damage.

Second, the selection and replacement of oil

  • 1. Selection of fuel oil. In order to soften the diesel engine and reduce fuel consumption, diesel with a lower freezing point should be used.
  • 2. Replacement of diesel engine oil. Diesel engines should use low-temperature engine oil with low viscosity and high performance. These oils are not easy to oxidize at high temperature, and will not leave deposits in the precision parts of diesel engines, which can greatly extend the life of diesel engines. When replacing oil, it should be replaced or Clean the oil filter.
  • 3. Replace the lubricating oil and grease. When changing seasons, replace the gear oil in the transmission, transfer case, differential, and steering gear with gear oil for winter. Pay attention to cleaning when changing oil.

Third, the maintenance of parts

  • 1. Maintenance of the sand production line of the diesel engine cooling system: check the working state of the thermostat to prevent the water temperature of the diesel engine from being too low or too high; remove the scale inside the water jacket; choose a long-term effect lower than the lower temperature of the construction machinery using a lower temperature of 10 буC. Antifreeze; once the tank is found to have silt deposits, it will be removed immediately.
  • 2. Maintenance of electrical equipment: check the motor wiring of the battery; check and adjust the electrolyte density; maintain the starting motor and increase the charging voltage of the generator; in winter, the battery should be charged frequently and the preheating device should be maintained.
  • 3. Maintenance of the brake system: Pay attention to whether the brake fluid is sufficient and whether the crushing quality is deteriorated; check whether the oil-water separator is working properly.

In order to enable the crusher to work properly in winter, it is necessary to do the maintenance work of the crusher, so as to reduce the cost of the fault and prolong the service life of the crusher. We have many years of advanced and rich technical experience in the production of crushers. We will inform new and old users of some details of the use of the equipment and maintenance precautions. In this cold weather, we should remind the users to keep warm.

Related Machine: